Wishiot ADXL345 Digital Accelerometer Module IIC/SPI 3-Axis Incl

Wishiot ADXL345 Digital Accelerometer Module IIC/SPI 3-Axis Inclination Tilt Sensor with 10Pin Female to Female/Female to Male Dupont Cable for Arduino Raspberry Pi (Pack of 2)

Description: The ADXL345 is low power, high resolution 13bit, 3-axis accelerometer Digital output, accessible through both SPI (3 or 4-wire) or I2C interface (formatted as 16-bit twos complement). ADXL345 will measure static acceleration and tilt as well as High G dynamic acceleration (motion or shock) 13 Bit resolution allows for inclination change measurements <1.0° (4 mg/LSB) ADXL345 will detect: motion or lack of motion acceleration on any axis exceeding user-defined level acceleration threshold sensing acceleration up to ±16 g Single or Double tap sensing (1 or 2 mouse clicks) Free-fall sensing motion mappable to one or two interrupt outputs Specifications: 2.0-3.6VDC Supply Voltage 0.1uA 2.5V, 40uA in normal mode SPI / I2C interfaces Female to Female cable is for ADXL345 with MCU which is onboard male pin header like Raspberry Pi board ADXL345 wiring with RPi board: 3V3--3.3V, GND--GND, SDA-- GPIO2, SCL--GPIO3. Female to Male cable is for ADXL345 with MCU which is onboard female header such as UNOR3board. ADXL345 wiring with UNOR3board: 3V3 --3.3V, GND--GND, CS--Pin10, SDA--Pin11, SDO--Pin12, SCL--Pin13. Package Included: 2 X ADXL345 Digital Accelerometer Sensor Module 1 X 10Pin 2.54mm Female to Female Dupont Cable 20cm 1 X 10Pin 2.54mm Female to Male Dupont Cable 20cm

Product Features

• 1, Onboard ADXL345 digital output (support I2C/SPI), low power consumption, compact accelerometer.
• 2, Support 5V/3.3V voltage input, onboard RT9161 power chip, lower voltage drop compared with chip 1117, faster load response speed, very suitable for high-noise power supply environment.
• 3, The commonly used pins have been drawn out, and it is soldered with standard 2.54mm pin header, which is convenient for dot matrix boards.
• 4, Prepared 2 cables for this module, Female to Female cable is for ADXL345 with MCU which is onboard male pin header like Raspberry Pi board, while Female to Male cable is for ADXL345 with MCU which is onboard female header such as UNOR3board.
• 5, What you will get is 2pcs ADXL345 Accelerometer module + 1pc 10Pin 2.54mm Female to Female Dupont Cable 20cm + 1pc 10Pin 2.54mm Female to Male Dupont Cable 20cm. 6, If you have any question, please contact us by clicking "Wishiot" under the shopping cart(you can find "Sold by Wishiot" under Buy Now button), in the new page, click "Ask a question" to email us.

Tags:dingo

Title - Default Title